ZZ
WCB-50P
delivery time: in stock
WCB-50P small food gear oil pump
The wcb gear oil pump can be used for the thin oil treatment of the thin oil lubricity system, and can be used for the thin oil transfer. Other liquids. It is installed together with the shaft and runs in a replaceable shaft sleeve. The safety valve of wcb gear pump can be adjusted according to actual needs within the allowable discharge pressure range. Note that this safety valve cannot be used for long-term work as a pressure reducing valve, and can be installed separately on the pipeline when necessary. A metal filter should be installed at the suction port to prevent particles such as impurities from entering the pump. Check whether the valves in the inlet and outlet pipes are open before starting the pump. Maintenance of wcb gear pump during operation: 1. The pressure of the pump and the reading of the vacuum gauge should meet the technical specifications specified by the pump. 2. Pay attention to the working conditions of the packing seal. If oil leakage occurs, the compression cover can be adjusted according to its degree (it is not allowed to press the compression cover too tightly, so as to avoid heat generation at the packing and rapid wear of the sealing ring). 3. When the pump has abnormal noise or high temperature rise during operation, the operation of the pump should be stopped immediately for inspection. When the pump stops working, the power supply should be cut off before closing the valve of the inlet pipeline. Product features: 1. Convenient maintenance and reliable performance. 2. Long service life and simple appearance. 3. The structure is advanced and reasonable, with the highest standards. 4. The conveying liquid must not contain solid particles. 5. The conveying temperature is not higher than 70℃
Troubles and troubleshooting of wcb portable gear pump: 1. No oil filling in the pump body can lead to no or less oil discharge; 2. No or less oil discharge caused by air leakage in the suction pipe, check all connections and tighten them ; 3. The oil pump does not discharge or discharges less oil due to too low revolutions, which needs to be checked and corrected with a tachometer; 4. The closed pipeline valve can cause the oil pump to not discharge or discharge less oil; 5. The safety valve cone is tight If there is no oil discharge or less oil discharge caused by poor conformity, it needs to be re-grinded with abrasive paste; 6. The oil pump sucks in the liquid and is not clean, and the sand or metal powder is mixed to make the tooth surface or both sides wear and scars will cause the mechanical seal to leak oil. 7. The pump fluid leakage caused by long-term wear and tear of the seal needs to be sealed with the correct sealing ring; 8. The abnormal noise of the oil pump caused by the improper assembly of various parts of the oil pump should be overhauled;
WCB-50P small food gear oil pump
Model parameters of wcb portable gear pump: WCB-30 portable gear pump Flow rate: 30L/min, conveying height: 30m, weight: 17kg, driving power: 370/550W, power supply: 220/380V; WCB-50 portable gear Pump flow: 50L/min, conveying height: 30m, weight: 19kg, driving power: 550W, power supply: 220/380V; WCB-75 portable gear pump flow: 75L/min, conveying height: 30m, weight: 21kg, Driving power: 750W, power supply: 220/380V; WCB-30P stainless steel portable gear pump flow: 30L/min, conveying height: 30m, weight: 17kg, driving power: 370/550W, power supply: 220/380V; WCB -50P stainless steel portable gear pump flow: 50L/min, conveying height: 30m, weight: 19kg, driving power: 550W, power supply: 220/380V; WCB-75P stainless steel portable gear pump flow: 75L/min, conveying height ：30m, weight: 21kg, driving power: 750W, power supply: 220/380 V;
