CLMAD waste heat regeneration adsorption dryer

Model number: CLMAD
Rated intake air temperature: ≤40 ° C
Rated working pressure: 0.7Mpa (0.4-1.0Mpa allowed)
Pressure drop: <0.02Mpa
Pressure dew is: -40 ℃
Regeneration method: Micro-heat regeneration
Control method: fully electronic programmable time control
Regeneration gas consumption: about 5% -8% of rated capacity
Adsorbent: activated alumina
Inlet gas oil content: <0.1mg / m3
Installation method: indoor, without foundation, leveling concrete floor
A: Working principle
New generation adsorption dryer, combining the advantages of pressure swing adsorption and temperature swing adsorption, adsorption (working) at normal temperature and high steam partial pressure; analysis (regeneration) at higher temperature and low steam partial pressure, that is, the adsorbent is in the adsorption process The moisture absorbed in the medium is completely removed during the regeneration process by the combined effects of the thermal diffusion and low partial pressure of high-quality regeneration gas (heated and dried air).
C. Model specifications
Adopt high-quality pneumatic butterfly valve, with reliable performance, stable switching and accurate action, to ensure the stable operation of the equipment.
Stainless steel electric heater, small size, high power, fast thermal response, high temperature control accuracy, high heating temperature and long service life.
Adopt special high-quality muffler, effectively reduce product noise.
Adopting high-quality pre-conducting magnetic valve, the action is accurate to ensure the stable operation of the equipment.
Adopting air purification professional adsorbent, it has the characteristics of strong adsorption capacity, high pressure resistance, wear resistance and temperature resistance, prolonging the service life of equipment and reducing operating costs.